SportageMotor

Kia Sportage: Cleaning the upholstery and interior trim

Kia Sportage - Fifth generation (NQ5) - (2022-2026) - Owner's Manual / Maintenance / Appearance care / Cleaning the upholstery and interior trim

Car interior surfaces

Remove dust and loose dirt from interior surfaces with a whisk broom or a vacuum cleaner. If necessary, clean interior surfaces with a mixture of warm water and mild non-detergent cleaner (test all cleaners on a concealed area before use).

Fabric

Remove dust and loose dirt from fabric with a whisk broom or vacuum cleaner.

Clean with a mild soap solution recommended for upholstery or carpets.

Remove fresh spots immediately with a fabric spot cleaner. If fresh spots do not receive immediate attention, the fabric can be stained and its color can be affected. Also, its fire-resistant properties can be reduced if the material is not properly maintained.

Using anything but recommended cleaners and procedures may affect the fabric's appearance and fire-resistant properties.

Cleaning the lap/shoulder belt webbing

Clean the belt webbing with any mild soap solution recommended for cleaning upholstery or carpet. Follow the instructions provided with the soap. Do not bleach or re-dye the webbing because this may weaken it.

Cleaning the interior window glass

If the interior glass surfaces of the vehicle become fogged (that is, covered with an oily, greasy or waxy film), they should be cleaned with a glass cleaner. Follow the directions on the glass cleaner container.

CAUTION

Rear window

Do not scrape or scratch the inside of the rear window. This may result in damage of the rear window defroster grid.

    READ NEXT:

     Emission control system

    The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Warranty & Consumer Information manual in your vehic

     Caution for the Inspection and Maintenance Test (With Electronic Stability Control (ESC) system)

    To prevent the vehicle from misfiring during dynamometer testing, turn the ESC off by pressing the ESC switch. After dynamometer testing is completed, turn the ESC back on by pressing t

     Operating precautions for catalytic converters

    WARNING Fire Do not park, idle or drive the vehicle over or near flammable objects, such as grass, vegetation, paper, leaves, etc. A hot exhaust system can ignite flammable items under yo

    SEE MORE:

     Reverse Parking Distance Warning malfunction and precautions

    Reverse Parking Distance Warning malfunction After starting the vehicle, a beep will sound once when the gear is shifted to R (Reverse) to indicate Reverse Parking Distance Warning is operating normally. However, if one or more of the following occurs, first check whether the ultrasonic sen

     Start/Stop Button | Fob Holder

    Components and Components Location  Component Connector (10 pins) Start stop button switch 1 LED illumination power Amber LED Start stop button illumination GND Start stop button illumination Power Ground Start stop button switch 2 Green LED R

    Content