Kia Sportage: Rear Body, Under Body
Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual / Body (Interior and Exterior) / Body Dimensions / Rear Body, Under Body
Rear Body
Body Repair
* These dimensions indicated in this figure are actual-measurement dimensions.
Under Body
Body Repair
Projected Dimensions
* These dimensions indicated in this figure are actual-measurement dimensions.
Actual-Measurement Dimensions
* These dimensions indicated in this figure are actual-measurement dimensions.
READ NEXT:
Fender | Hood
Repair procedures
Replacement
CAUTION
When removing and installing the fender, an assistant is necessary.
Be careful not to damage the fender and body.
When removing the clips
SEE MORE:
Installation - Repair procedures
Installation
1. Install the balance shaft chain. (Refer to Lubrication system in this
group)
2. Install the crankshaft chain sprocket (B) and the timing chain oil jet
(A).
Tightening torque:
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
3. Set the crankshaft so that the key (A) of cranksh
Repair method for PP bumper
Damage to the bumper that reaches the surface of the polyporpylene cannot be
fixed just by painting. Use the repair
methods shown below to repair damage that reaches the surface of the
polypropylene.
1. Rough cut the damaged area 45º using a
knife and then sand the angle smooth.
2. W
Content
- Home
- Kia Sportage - Fifth generation (NQ5) - (2022-2026) - Owner's Manual
- Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual
- Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual
- Sitemap
- Top articles
