Kia Sportage: Body Dimensions
READ NEXT:
General
1. Basically, all measurements in this manual are taken with a tracking gauge.
2. When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3. For
Body Repair
Side Body A
* These dimensions indicated in this figure are actual-measurement dimensions.
Side Body Ð’
* These dimensions indicated in this figure are actu
SEE MORE:
Description and Operation
Description
1. Mode
Configuration State
All sensors should be in the Low Line (Base) state.
In Low Line (Base) configuration, sensor transmissions occur every 3
minutes 20 seconds (nominal) and
pressure is measured every 20 seconds.
Normal
Components and
Components Location
Component Location
Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based on
signal of Ð/С control unit. Pressing
mode s
General Information | Front Body
