Kia Sportage: Rear Suspension System
Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual / Suspension System / Rear Suspension System
- Components and Components Location | Rear Shock Absorber
- Rear Upper Arm | Rear Lower Arm
- Rear Stabilizer Bar | Rear Assist Arm
- Trailing Arm | Rear Cross Member
READ NEXT:
Components and Components Location | Rear Shock Absorber
Components Location
Sub frame
Assist arm
Upper arm
Lower arm
Trailing arm
Rear axle
Coil spring
Shock absorber
Drive shaft
Stabilizer
Rear Upper Arm | Rear Lower Arm
Repair procedures
Replacement
1. Remove the rear wheel & tire.
Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
CAUTION
Be careful not to damage to the hub bolts
SEE MORE:
Ignition Switch Assembly
Repair procedures
Inspection
1. Disconnect the ignition switch connector (B) and key warning switch
connector (A) from under the steering column.
2. Check for continuity between the terminals.
3. If continuity is not specified, replace the switch.
Removal
1. Disconnect the nega
USB charger
The USB car charger allows drivers to
charge their digital devices such as
smartphones, and PC tablets.
Front
Plug the cable into the USB port, and
charging will begin.
The USB car charger is available with
either the ACC on or the ignition on. We
recommend you connect the USB port
and
Content
- Home
- Kia Sportage - Fifth generation (NQ5) - (2022-2026) - Owner's Manual
- Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual
- Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual
- Sitemap
- Top articles
