Kia Sportage: Electro chromic Inside Rear View Mirror
Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual / Body Electrical System / Electro chromic Inside Rear View Mirror
READ NEXT:
Components and ComponentsLocation | Description and Operation
Components Location
[ECM]
-
OEC (+)
-
-
-
-
OEC (-)
GND
Reverse signal
IGN (+)
[Reverse Display]
Camera power (-)
OEC
Repair procedures
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1. Turn the ignition key to the "ON" position.
2. Cover the forward facing sensor.
3. He
SEE MORE:
Repair procedures
Removal
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3. Remove the BCM (A) after removing the nuts, connectors and antenna cable.
Installation
1. Install the BCM after connecting the connectors and cab
High Beam Assist (HBA)
A: Vehicle Settings
Lights
High Beam Assist
With the ENGINE START/STOP button in
the ON position, select 'Lights ? High
Beam Assist' from the Settings menu to
turn on High Beam Assist and deselect
to turn off the function.
WARNING
For your safety, adjust your high beam
Content
- Home
- Kia Sportage - Fifth generation (NQ5) - (2022-2024) - Owner's Manual
- Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual
- Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual
- Sitemap
- Top articles
