SportageMotor

Kia Sportage: Storing memory positions

Kia Sportage - Fifth generation (NQ5) - (2022-2025) - Owner's Manual / Features of your vehicle / Driver Position Memory System / Storing memory positions

The Driver Position Memory System is provided to store and recall the following memory settings with a simple button operation.

  • Driver's seat position
  • Outside rear view mirror position
  • Instrument panel illumination intensity

WARNING

Never attempt to operate the driver position memory system while the vehicle is moving.

This could result in loss of control, and an accident causing death, serious injury, or property damage.

NOTICE

  • If the battery is disconnected, the memory settings will be erased.
  • If the Driver Position Memory System does not operate normally, have the system checked by an authorized Kia dealer.

Storing memory positions

  1. The ignition switch or ENGINE START/ STOP button is in the ON position.
  2. Adjust the driver's seat position, outside rear view mirror position, instrument panel illumination intensity to the desired position.
  3. Press one of the memory buttons (1 or 2) for more than 1 second. The system will beep twice.
  4. "Settings 1 (or 2) saved" will appear on the LCD display.

Recalling memory positions

  1. The ignition switch or ENGINE START/ STOP button is in the ON position.
  2.  Press the desired memory button (1 or 2). The system will beep once, and then the driver's seat position, outside rear view mirror position, instrument panel illumination intensity will automatically adjust to the stored positions.
  3. "Settings 1 (or 2) applied" will appear on the LCD display.
  • While recalling the "1" memory position, pressing 1 button temporarily stops the adjustment of the recalled memory position. Pressing the 2 button recalls the "2" memory position.
  • While recalling the "2" memory position, pressing the SET or 2 button temporarily stops the adjustment of the recalled memory position. Pressing the 1 button recalls the "1" memory position.
  • While recalling the stored positions, pressing one of the control buttons for the driver's seat, outside rear view mirror, or instrument panel illumination will cause the movement of that component to stop and move in the direction that the control button is pressed.

    READ NEXT:

     Driver position memory system reset

    If the Driver position memory system does not work properly, initialize the system as follows. How to initialize: Stop the vehicle and open the driver's door with the ignition switch or

     Liftgate

     Opening the liftgate

    Liftgate WARNING Exhaust fumes If you drive with the liftgate open, you will draw dangerous exhaust fumes into your vehicle which can cause serious injury or death to vehicle occupants. If yo

    SEE MORE:

     Antenna | Audio Remote Control

    Repair procedures  Inspection Antenna Cable 1. Remove the antenna jack from the audio unit and antenna. 2. Check for continuity between the center poles of antenna cable. 3. Check for continuity between the outer poles of antenna cable. There should be continuity. 4. If there is no c

     Defroster

    The vehicle is equipped with a defroster for removing frost or fog from the rear window. CAUTION Conductors To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window. If you w

    Content