SportageMotor

Kia Sportage: А/С Pressure Transducer | Evaporator Temperature Sensor

Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual / Heating, Ventilation, Air Conditioning / Air Conditioning System / А/С Pressure Transducer | Evaporator Temperature Sensor

Components and Components Location

 Component Location

Description and Operation

Description and Operation

 Description

А/С pressure transducer convert the pressure value of high pressure line into voltage value after it is measured. By voltage value, the engine ECU controls cooling fan by operating it high speed or low speed. Engine ECU stops the operation of compressor when the temperature of refrigerant line is too high or too low to optimize air conditioning system.

Repair procedures

Inspection

1. Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals.

2. Inspect the voltage value whether it is sufficient to be regular value or

2. Inspect the voltage value whether it is sufficient to be regular value or not.

Voltage = 0.00878835 * Pressure + 0.37081095 [PSIA]

3. If the measured voltage value is not specification, replace the А/С pressure transducer.

Replacement

1. Disconnect the negative (-) battery terminal.

2. Recover the refrigerant with a recovery/charging station.

3. Disconnect the А/С pressure transducer connector (3P) (A).

Tightening torque: 10~12 N.m (1.0~1.2 kgf.m, 7.4~8.8 lb-ft)

CAUTION

CAUTION

Take care that liquid & suction pipe are not bent.

4. Installation is the reverse order of removal.

Evaporator Temperature Sensor

Description and Operation

 Description

The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator freezing by excessive cooling.

Repair procedures

Inspection

1. Ignition "OFF".

2. Disconnect evaporator temperature sensor.

3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor.

Specification

Specification

Replacement

Replacement

1. Remove the console extension cover (A).

2. Remove the evaporator temperature sensor (A), by pulling it after rotating

2. Remove the evaporator temperature sensor (A), by pulling it after rotating 90º in a clockwise direction.

3. Installation is the reverse order of removal.

3. Installation is the reverse order of removal.

    READ NEXT:

     Photo Sensor | Ambient Sensor

    Description and Operation Description 1. The photo sensor is located at the right of defrost nozzle. 2. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation

    SEE MORE:

     Corrosion protection

    Protecting your vehicle from corrosion By using the most advanced design and construction practices to combat corrosion, we produce vehicles of the highest quality. However, this is only part of the job. To achieve the long-term corrosion resistance your vehicle can deliver, the owner's c

     Components and Components Location, Description and Operation

    Components and Components Location  Components Location Receiver TPMS Sensor TPMS Sensor TPMS Sensor TPMS Sensor Description and Operation  Description TREAD Lamp Tire Under Inflation / Leak Warning. 1. Turn on condition When tire pressure is below allowed

    Content