Kia Sportage: Heating, Ventilation, Air Conditioning
Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual / Heating, Ventilation, Air Conditioning
- General Information, Troubleshooting, Special Service Tools
- Air Conditioning System
- General Safety Information and Caution
- Repair procedures
- Components and Components Location | Compressor Oil
- Refrigerant line | Compressor
- Condenser | Receiver-Drier
- Ð/С Pressure Transducer | Evaporator Temperature Sensor
- Photo Sensor | Ambient Sensor
- Cluster ionizer
- Heater
- Blower
- Blower Unit | Blower Motor
- Power Mosfet | Blower Resistor | Climate Control Air Filter
- Intake Actuator
- Controller
READ NEXT:
General Information, Troubleshooting, Special Service Tools
General Information
Specification
Air Conditioner
Blower Unit
Heater And Evaporator Unit
Troubleshooting
Troubleshooting
Problem Symptoms Table
Before replacing or repairing
General Safety Information and
Caution
Instructions
When Handling Refrigerant
1. R-134a liquid refrigerant is highly volatile. A drop on the skin of your
hand could result in localized frostbite.
When handling the refrigerant,
SEE MORE:
Rear Glass Defogger Switch
Repair procedures
Removal
1. Disconnect the negative (-) battery terminal.
2. Remove the center fascia panel.
(Refer to BE - "Audio")
3. Remove the heater and Ð/С controller (A) after disconnecting the connector
(B).
NOTE
Take care not to damage the hook when removing
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Pails' Resistance
The measured resistance at high temperature after vehicle running may be high
or low. So all resistance must be
measu
Content
- Home
- Kia Sportage - Fifth generation (NQ5) - (2022-2026) - Owner's Manual
- Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual
- Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual
- Sitemap
- Top articles
