Kia Sportage: SRSCM
READ NEXT:
Description and Operation
Description
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between
an event that warrants restraint system dep
Description and Operation
Description
The front impact sensor (FIS) is installed in the Front End Module (FEM).
They are remote sensors that detect
acceleration due to a collision at its mo
Description and Operation
Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at
each center of the front door module
(LH and RH) and two SIS which are ins
SEE MORE:
Specifications
Specifications
Tightening Torques
Repair procedures
Compression Pressure Inspection
NOTE
If the there is lack of power, excessive oil consumption or poor fuel
economy, measure the compression pressure.
1. Warm up and stop engine.
Allow the engine
Removal
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3. Remove the BCM (A) after removing the nuts, connectors and antenna cable.
Installation
1. Install the BCM after connecting the connectors and cab
SRS Control Module (SRSCM)
