SportageMotor

Kia Sportage: Cylinder Head Assembly

Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual / Engine Mechanical System / Cylinder Head Assembly

READ NEXT:

 Camshaft

Repair procedures  Removal Timing chain cover removal is not required for this procedure. CAUTION Use fender covers to avoid damaging painted surfaces. To avoid damaging the cylinder hea

 Cylinder Head | Removal - Repair procedures - Cylinder Head

Components and Components Location  Components Camshaft bearing cap Camshaft front bearing cap Exhaust camshaft Intake camshaft Exhaust CVVT assembly Intake CVV

SEE MORE:

 Thermostat

Repair procedures Removal and Installation NOTE Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat. 1. Drain engine coolant so its level is below thermostat. 2. Disconnect

 Vehicle lift (2-Support type) and safety stand positions

1. Place the lift blocks under the support points as shown in the illustration. 2. Raise the hoist a few inches and rock the vehicle to be sure it is firmly supported. 3. Raise the hoist to full height to inspect the lift points for secure support. Jack and safety stand positions Towin

Content