Kia Sportage: Engine Mechanical System
Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual / Engine Mechanical System
- General Information
- Engine And Transaxle Assembly
- Timing System
- Cylinder Head Assembly
- Camshaft
- Cylinder Head | Removal - Repair procedures - Cylinder Head
- Inspection - Repair procedures - Cylinder Head
- Installation - Repair procedures - Cylinder Head
- Cylinder Block
- Components and ComponentsLocation | Disassembly - Repair procedures
- Inspection - Repair procedures
- Reassembly - Repair procedures
- Cooling System
- Lubrication System
- Intake And Exhaust System
READ NEXT:
General Information
Specifications
Specifications
Tightening Torques
Repair procedures
Compression Pressure Inspection
NOTE
If the there is lack of power, excessive oil consumption or poor
Engine And Transaxle Assembly
Engine Mounting
Components and
Components Location
Components
Transaxle mounting bracket
Roll rod bracket
Sub frame
Engine mounting bracket
Engine mounting support
bracket
SEE MORE:
Cruise Control Switch
Schematic Diagrams
Circuit Diagram
[Auto Cruise Control]
Connector RH
ILL (-)
ILL (+)
-
-
-
ACC GND
ACC signal
ACC power
Repair procedures
Removal and Installation
1. Disconnect the battery (-) terminal.
Tightening torque:
Without battery sensor:
7.8 ~ 9.8N.m (
Auto control
The rain sensor (A) located on the upper
end of the windshield glass senses the
amount of rainfall and controls the wiping
cycle for the proper interval. The
more it rains, the faster the wiper operates.
When the rain stops, the wiper
stops.
To vary the speed setting, turn the
speed
Content
- Home
- Kia Sportage - Fifth generation (NQ5) - (2022-2026) - Owner's Manual
- Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual
- Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual
- Sitemap
- Top articles
