SportageMotor

Kia Sportage: Radiator support panel

Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual / Body structure / Zine-galvanized steel sheet used area / Radiator support panel

  1. Radiator support panel complete

Fender apron panel

  1. Fender apron panel assembly
  2. Front side outer member assembly

Cowl panel & Dash panel

  1. Cowl panel complete
  2. Cowl side outer panel
  3. Dash panel complete

    READ NEXT:

     Side body panel

    Front inner pillar assembly Quarter inner panel assembly Side outer rear extension assembly Quarter outer panel assembly Center outer pillar assembly Pillar outer panel assembly Side

     Roof panel (Without sunroof)

    Roof front rail assembly Roof rear rail assembly Roof panel Roof center No.1 rail Roof center No.2 rail Roof center No.3 rail Roof panel (With sunroof) Roof front rail assembly

     Fender panel & Hood panel & Tail gate panel

    Hood panel assembly Hood hinge assembly Fender panel Tail gate panel assembly Tail gate hinge assembly Door panel Front door panel assembly Rear door panel assembly Front doo

    SEE MORE:

     Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the BCM (A) after removing the nuts, connectors and antenna cable. Installation 1. Install the BCM after connecting the connectors and cab

     Hitches

    If you are considering towing with your vehicle, you should first check with your country's Department of Motor Vehicles to determine their legal requirements. Since laws vary the requirements for towing trailers, cars, or other types of vehicles or apparatus may differ. Kia recommends

    Content

    2022-2026 © - www.sportagemotor.com | Privacy Policy