Kia Sportage: Fender panel & Hood panel & Tail gate panel
Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual / Body structure / Zine-galvanized steel sheet used area / Fender panel & Hood panel & Tail gate panel
- Hood panel assembly
- Hood hinge assembly
- Fender panel
- Tail gate panel assembly
- Tail gate hinge assembly
Door panel
- Front door panel assembly
- Rear door panel assembly
- Front door hinge assembly
- Rear door hinge assembly
READ NEXT:
Replacing body panels
Replacing body panels
Codes for disassembling and assembling body panels
Disassembling spot welded area
Most body parts are spot welded. In order to disassemble the damaged area, it
is best to disassemble the spot
welded area from the body frame using a spot cutter or candle type edge drill
bit. Do
SEE MORE:
Thermostat
Repair procedures
Removal and Installation
NOTE
Disassembly of the thermostat would have an adverse effect, causing a
lowering of cooling efficiency. Do not
remove the thermostat, even if the engine tends to overheat.
1. Drain engine coolant so its level is below thermostat.
2. Disconnect
TPMS Receiver
Components and
Components Location
Components
TPMS Receiver Circuit Diagram
Harness Connector
Battery
CAN_High
GND
-
-
-
IGN
CAN_Low
-
-
-
-
Description and
Operation
Description
1. Mode
Virgin State
The receiver as a sole part is shipped
Content
- Home
- Kia Sportage - Fifth generation (NQ5) - (2022-2026) - Owner's Manual
- Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual
- Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual
- Sitemap
- Top articles
